| |||||||||
| Discharge End View | ||||||||
| Discharge Housing with Spring Loaded Seal Arrangement on PATTERSON 48" (1.22m) dia. Continuous Ball Mill. | ||||||||
| PATTERSON 5'0" (1.52m) dia. x 16'0" (4.88m) long Continuous Ball Mill for grinding of Limestone used in Decorative Facings and Wall Retaining Blocks. | ||||||||
| PATTERSON Continuous Duty Rod Mill, 66" diameter x 196" long, with abrasion resistant cast lining (rubber mounted) and 125 HP motor. Charge End Side View. | ||||||||
| Charge End Rear View. | ||||||||
| Discharge End Front View. | ||||||||
| Close-up of Cast linings of Mill End. | ||||||||
| Interior view of Mill Cylinder with Cast Lifter Bars installed. | ||||||||
| View of Drive Train and Support Rollers. | ||||||||
| Close-up of Heavy Duty Support Rollers. | ||||||||
| Mill Cylinder with Tires and Ring Gear ready for shipment. | ||||||||
| PATTERSON
4'0" (1.21 m) diameter x 24'0" (7.31 m) long Continuous type
Ball Mill with 60 psi certified Cooling Jacket and automatic Lubrication
System. Mill built to
Standards. - Front Charge End View. | ||||||||
| Close-up Front View of Drive Arrangement. | ||||||||
| Front Close-up of Charge Drive End. | ||||||||
| Close-up of Drive Bearing | ||||||||
| Front close-up of Dustless Discharge End. | ||||||||
| Close-up of Dustless Discharge Housing. | ||||||||
| Front End View of Discharge End. | ||||||||
| Close-up End View of Non-Drive End with Rotary Union. | ||||||||
|
Close-up views of Automatic Lubrication System for PATTERSON Mill featured above installed before disconnection and disassembly for shipment.
| |||||||||
| Main Station with 24 Volt DC connection. | ||||||||
| Inlet End Side. | ||||||||
| Inlet End Front Bearing View. | ||||||||
| Close up of Distributors on Drive Side End. | ||||||||
| Drive Bearing. | ||||||||
| Non-Drive Discharge End Front View. | ||||||||
| Close-up of Distributor on Non-Drive End. | ||||||||
| Close-up of Non-Drive Side Bearing. | ||||||||
| Close-up top view of Non-Drive Side Discharge End Bearings showing Automatic Lubrication System Connections. | ||||||||
| Full Close-up of Non-Drive Side Bearing. | ||||||||
 | Top Side View of Non-Drive Side Bearing. | ||||||||
|
| |||||||||
| Drive Side view with Product Inlet of PATTERSON 4'0" dia x 24'0" long Jacketed Continuous Ball Mill with 60 psi rated Cooling Jacket for wall board additives. | ||||||||
| Non-Drive Side View. | ||||||||
| Discharge End View. | ||||||||
| Close up of Discharge Housing. | ||||||||
| Close-up of Large Bearing with Rotary Union for Cooling Water. | ||||||||
